Categories
slide 1 slide 3 slide 2 slide 4 slide 5 slide 6 slide 7

TURBINES & PUMPS

Show:
Sort By:
A low lift but continuous flow displacement pump. All metallic model, complete with water reservoir ..
The model is of the best known turbine working on 40 lb per square inch steam pressure. Buckets are ..
 Deepwell Turbine Pump
This is a working model mounted on cast iron base. Turbine pump is fitted at the bottom and 220 volt..
 Different Impellers of Pumps & Turbines
Each model mounted separately on wooden base. a Mixed Flow Runner Cast Aluminium 180 mm in Dia b..
 Hydraulic Press Model
Very superior with cast metallic parts, actual working model fitted on metal base. ..
The section cut big size non working model of the most powerful turbine is fitted on wooden base wit..
Same as per Cat no. 1285 but equipped with a dynamometer, simple zero non resetlable revolution coun..
 Pendulum Pump
The water lifting device is consisting of a pendulum frame alternately dips, scope and raises water ..
 Pure Reaction Turbine
Hero’s type large size working model, All metal Parts, fitted on a heavy cast iron base and with a h..
It is an all metallic properly constructed model, one side is covered with plexi glass showing inter..
This is an all metallic, properly constructed, small size model. Vanes driven by inner slotted cylin..
 Submersible Pump
A non-working model. The pump along with driving motor is placed in a section out housing of tube we..
This is an all metallic two stage working model, properly constructed. The rotor with shaft is on ba..
Original second hand, section cut and repainted model. ..
Centrifugal Pump (Model)
An all metallic section cut small size demonstration model made of cast aluminium parts. Rotator pre..
Copyright © 2014 Etherengineers. All rights Reserved